The short version of secondary drying fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-05-17. Anything still debated is marked as such rather than presented as settled.
A freeze-dryer consists of a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. Vials, ampoules, or bulk trays hold the product during the cycle. The condenser traps water vapor as ice at a temperature lower than the product. Cycle development balances shelf temperature, chamber pressure, and time. Scale-up can be difficult because heat and mass transfer change with equipment size, so process analytical tools and conservative validation are often used.
Lyophilization is a dehydration technique in which a product is frozen and the solvent is removed under reduced pressure. The low pressure allows ice to sublimate directly into vapor without passing through a bulk liquid phase. This differs from conventional drying, where heat drives evaporation and can damage heat-sensitive structures. The process is used for biological materials, pharmaceutical formulations, and some foods. Its main advantage is preservation of porous structure and rapid reconstitution.
Freezing is the first stage and sets the ice structure that later becomes the pore network. The formulation is cooled below its freezing point, often with a controlled ramp, and solutes concentrate as ice forms. Primary drying then lowers chamber pressure and supplies heat to sublime the ice. The product temperature must stay below its collapse or eutectic temperature to prevent structural loss. Secondary drying raises the temperature modestly to remove bound water and achieve a low residual moisture.
Quality control for freeze-dried forms includes visual inspection, water content measurement, and reconstitution time. A satisfactory cake is typically uniform, porous, and intact, although minor shrinkage or cracking may be acceptable if specifications allow. Karl Fischer titration, thermal gravimetric analysis, and near-infrared spectroscopy are used to measure water content. Reconstitution is assessed by adding a specified diluent and recording the time and ease of dissolution. Microbiological and particulate tests are added when the product is sterile or intended for injection.
Stability of a lyophilized solid depends on water content, temperature, and the physical state of the formulation. Amorphous products may slowly absorb moisture and drop below their glass transition temperature, causing collapse or crystallization. Some proteins and peptides can aggregate even in a dry state, especially when exposed to heat or moisture. Accelerated stability studies at elevated temperature and humidity help estimate shelf life, but real-time data remain the basis for expiration dating.
| Property | Value | Notes |
|---|---|---|
| Common synonyms | freeze-drying, lyophilisation, cryodesiccation | Lyophilization is common in pharmaceutical literature. |
| Typical chamber pressure during primary drying | 0.05–0.5 mbar (5–50 Pa) | Must remain below the triple point of water. |
| Typical shelf temperature during freezing | −40 to −20 °C | Lower temperatures may be used for eutectic systems. |
| Typical residual moisture after secondary drying | 0.5–3% w/w | Product-dependent; low moisture improves stability but can cause over-drying. |
| Typical analytical method for residual moisture | Karl Fischer titration or loss on drying | Thermogravimetric methods are also used. |
Freeze-drying is distinct from simple evaporation and from spray drying. Evaporation removes water at temperatures above freezing, while spray drying rapidly dries droplets in a heated gas stream. Lyophilization avoids high temperatures, which can be useful for heat-sensitive materials such as proteins, vaccines, and some foods. The porous cake produced by sublimation dissolves or rehydrates more quickly than a dense dried mass. Not all materials tolerate freezing or the pH shifts that can occur as solutes concentrate during ice formation.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and fixes the structure of the sample. After freezing, primary drying lowers pressure so ice changes directly to vapor without passing through a liquid phase. Secondary drying then removes bound water that remains after ice sublimation. The result is a dry, porous solid that often retains its original shape.
Storage conditions for dried products usually aim to exclude moisture and oxygen. Vials are sealed under vacuum or with an inert gas, and stoppers must maintain a barrier during transport. Temperature recommendations vary; some materials remain stable at room temperature, while others need refrigeration or frozen storage. Humidity control is critical because dried cakes can absorb water rapidly once a container is opened. Desiccant packs and moisture-barrier bags add further protection during shipping.
Quality control also examines cake structure, color, and reconstitution behavior. A collapsed or shrunken cake can indicate a thermal excursion during drying. Analytical methods such as X-ray diffraction, differential scanning calorimetry, and near-infrared spectroscopy can detect crystallinity or moisture distribution. Regulatory expectations focus on validated assays and lot-to-lot consistency. Questions remain about how well accelerated stability tests predict long-term behavior for every formulation. Visual inspection remains common but is subjective without trained reviewers and reference images.
=== Neonatal abstinence === Buprenorphine has been used in the treatment of the neonatal abstinence syndrome, a condition in which newborns exposed to opioids during pregnancy demonstrate signs of withdrawal. In the United States, use currently is limited to infants enrolled in a clinical trial conducted under an FDA-approved investigational new drug (IND) application. Preliminary research suggests that buprenorphine is associated with shorter time in hospital for neonates, compared to methadone. An ethanolic formulation used in neonates is stable at room temperature for at least 30 days.
Benzodiazepines developed in the former Soviet Union (e.g. phenazepam, gidazepam etc.) Benzodiazepines predominantly used only in Japan (e.g. nimetazepam, flutoprazepam etc.) 4,5-cyclised benzodiazepines (e.g. ketazolam, cloxazolam etc.), and other compounds not researched by Roche Benzodiazepines developed more recently (e.g. remimazolam, QH-ii-066, Ro48-6791 etc.) "Designer" benzodiazepines for which in vitro binding data are unavailable (e.g. flubromazolam, pyrazolam etc.) While binding or activity data are available for most of these compounds also, the assay conditions vary between sources, meaning that in many cases the values are not suitable for a direct comparison. Many older sources used animal measures of activity (i.e. sedation or anticonvulsant activity) but did not measure in vitro binding to benzodiazepine receptors. See for instance Table 2 vs Table 11 in the Chem Rev paper, Table 2 lists in vitro pIC50 values matching those below, while Table 11 has pEC50 values derived from in vivo assays in mice, which show the same activity trends but cannot be compared directly, and includes data for compounds such as diclazepam and flubromazepam which are not available in the main data set. Also note;
In 2009, 86% of cadmium was used in batteries, predominantly in rechargeable nickel–cadmium batteries. Nickel–cadmium cells have a nominal cell potential of 1.2 V. The cell consists of a positive nickel hydroxide electrode and a negative cadmium electrode plate separated by an alkaline electrolyte (potassium hydroxide). The European Union put a limit on cadmium in electronics in 2004 of 0.01%, with some exceptions, and in 2006 reduced the limit on cadmium content to 0.002%. Another type of battery based on cadmium is the silver–cadmium battery.
== Diagnosis == One of the most important factors used to determine the clinical suspicion of malignancy of an adnexal mass is the sonographic (ultrasound) appearance of the mass. Indications that the mass is at a higher risk of being malignant include the presence of loculations, nodules, papillary structures, septations, or a size greater than 10 cm.
Sources: en.wikipedia.org
On July 16, 2021, the Grand Commander of the Supreme Council of Cuba at the time, José Ramón Viñas Alonso, wrote another letter to President Miguel Díaz-Canel. This one was much more direct than the Grand Master's letter, and outright rejected the authority of the President of Cuba. In the letter, he admonished the President's choices and actions during the event, and condemned what he called government repression of the protest. He wrote that in the Supreme Council's considered opinion, President Díaz-Canel had intentionally and purposefully sent armed government police to use violence against the Cuban people, to arrest peaceful demonstrators, and to curtail the voice of anyone who "...thinks contrary to the system that you represent..." Even more critically, Viñas Alonso accused the President of using the United States embargo against Cuba as an excuse for any lack of ability that the Cuban government possessed in the day-to-day governing of the country, and that in doing so, the President avoided truly addressing the ineffectiveness of the government.Later in the afternoon of July 16, Grand Commander Viñas Alonso was summoned to Castro Police Station at the corner of Calle Unidad (English: Unidad Street) and Calle C (English: C Street) in Plaza de la Revolución. At the police station, Viñas Alonso was interrogated by three federal agents of the State Security Unit. In August 2021, Grand Master Ernesto Zamora Fernández was invited to attend a private meeting with Díaz-Canel, but Grand Commander Viñas Alonso was not invited.
== Preparation and composition == Some Native Americans used mashed pumpkin or devil's club as a poultice. In addition to bread and cereals, bran may also be used as a poultice because of its absorbent quality. It is packed into the wound and then covered with a piece of sacking or similar material before being bandaged onto the site of the wound. There are also many commercial poultices that are ready-made. Some of these may be labeled as "drawing salves". Ash poultices can cause a chemical burn.
=== Early years === Brothers Jim and William Reid formed a band in the early 1980s in response to their distaste of the music at the time, saying, "It was the crap coming out of the radio that made us want to be in a band". This worked in their favour, as William said, "It was perfect timing because there weren't any guitar bands. Everybody was making this electronic pop music." Before forming the band, the brothers had spent five years on the dole, during which they wrote and recorded songs at home and worked out the sound and image of the band. Originally called The Poppy Seeds, and then Death of Joey, they initially told journalists that they had taken their eventual name from a line in a Bing Crosby film, although six months later they admitted that this was not true. Other accounts suggest that the name derived from an offer on a breakfast cereal packet, where customers could send off for a gold Jesus & Mary chain. As neither brother wanted to be the singer, they decided on Jim via coin toss. The brothers started recording and sending demos to record companies in 1983 (using a Portastudio bought with £300 given to them by their father from redundancy pay after he lost his factory job), and by early 1984 they had recruited bass player Douglas Hart and teenage drummer Murray Dalglish. Early influences included the Velvet Underground, the Stooges, New York Dolls, Suicide, the Shangri-Las, and Einstürzende Neubauten.
=== Metabolism === Among the many metabolic processes in which it participates, glutathione is required for the biosynthesis of leukotrienes and prostaglandins. It plays a role in cysteine storage. Glutathione enhances the function of citrulline as part of the nitric oxide cycle. It is a cofactor and acts on glutathione peroxidase. Glutathione facilitates metabolism of xenobiotics. Glutathione S-transferase enzymes catalyze its conjugation to lipophilic xenobiotics, facilitating their excretion or further metabolism. The conjugation process is illustrated by the metabolism of N-acetyl-p-benzoquinone imine (NAPQI). NAPQI is a reactive metabolite formed by the action of cytochrome P450 on paracetamol (acetaminophen). Glutathione conjugates to NAPQI, and the resulting ensemble is excreted. As a result of this reaction, cellular glutathione concentration tends to be depleted in the presence of acetaminophen.
=== Treponema repeat family of proteins === The Treponema repeat family of proteins (Tpr) are proteins expressed during the infection process. Tprs are formed by a conserved N-terminal domain, an amino-terminal stretch of about 50 amino acids, a central variable region, and a conserved C-terminal domain. The many different types of Tpr include TprA, TprB, TprC, TprD, and TprE, but variability of TprK is the most relevant due to the immune escape characteristics it allows. Antigen variation in TprK is regulated by gene conversion. In this way, fragments of the seven variable regions (V1–V7), by nonreciprocal recombination, present in TprK and the 53 donor sites of TprD can be combined to produce new structured sequences. TprK antigen variation can help T. pallidum to evade a strong host immune reaction and can also allow the reinfection of individuals. This is possible because the newly structured proteins can avoid antibody-specific recognition. It is also suspected that the genes that encode for the TprK protein are essential in pathogenesis during the infection of syphilis. To introduce more phenotypic diversity, T. pallidum may undergo phase variation. This process mainly happens in TprF, TprI, TprG, TprJ, and TprL, and it consists of a reversible expansion or contraction of polymeric repeats. These size variations can help the bacterium to quickly adapt to its microenvironment, dodge immune response, or even increase affinity to its host.
Sources: en.wikipedia.org
Yes, the terms are generally interchangeable. Lyophilization is more common in pharmaceutical and laboratory contexts, while freeze-drying appears widely in food science and general writing. Both describe removal of solvent by sublimation under vacuum after freezing.
Reduced pressure keeps the process below the triple point of water, so ice can sublimate directly to vapor. It also lowers the temperature needed for drying, which helps preserve heat-sensitive materials. Without vacuum, melting or boiling could occur instead of controlled sublimation.
The rate depends on heat transfer to the product and mass transfer of vapor through the dried layer. A cold condenser, adequate vacuum, and suitable shelf temperature all influence speed. Formulation properties such as solid content and collapse temperature also set practical limits.
Sealed vials or containers should be kept at the temperature specified by stability data, often controlled room temperature or 2–8 °C. Moisture and oxygen barriers are important because both can degrade sensitive materials. Opened containers may need immediate use or protection from ambient humidity.