The short version of sublimation fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-09-29. Anything still debated is marked as such rather than presented as settled.
Lyophilization is a drying process in which a solvent, usually water, is removed from a frozen material by sublimation under reduced pressure. The material is first solidified, then placed under vacuum so that ice transitions directly to vapor without a bulk liquid phase. This approach suits heat-sensitive substances that would degrade during conventional evaporation. Primary drying removes unbound ice, while secondary drying reduces water that remains adsorbed to the solid matrix. The result is a porous, lightweight solid that can be reconstituted later.
A typical cycle begins with freezing, sometimes including an annealing step to control ice crystal size. Freezing conditions influence the pore network that later allows vapor escape. During primary drying, shelf temperature and chamber pressure are set so heat enters the product while its temperature stays below the collapse or eutectic point. Secondary drying then raises the shelf temperature to desorb bound water and lower residual moisture. Cycle design depends on formulation, fill volume, container type, and equipment capability.
Lyophilization, also called freeze-drying, removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts free water into ice and may also produce a glassy phase. Primary drying then lowers chamber pressure so ice sublimes directly to vapor without passing through a liquid stage. Secondary drying raises the temperature modestly to remove bound water. The result is a porous, dry solid that usually reconstitutes quickly. Each stage influences pore structure, residual moisture, and stability.
The physics of lyophilization depends on phase boundaries and heat and mass transfer. During primary drying, heat supplied to the product must equal the latent heat of sublimation, while water vapor moves through the drying cake to the condenser. If shelf temperature or pressure is set too high, the ice front can exceed the collapse temperature, causing meltback or pore collapse. If conditions are too cold, drying slows and costs rise. Formulation excipients, vial geometry, and freezing rate alter these limits.
| Property | Value | Notes |
|---|---|---|
| Physical state | Solid, porous cake or powder | Depends on formulation and container |
| Typical storage temperature | 2–25 °C, protected from moisture | Some materials require colder conditions |
| Solubility class | Usually readily soluble after reconstitution | Not an intrinsic chemical property |
| Common analytical method | Karl Fischer titration | Used for residual moisture |
| Common synonyms | Freeze-drying; lyophilisation | Lyophilisation is a spelling variant |
Lyophilization removes water by freezing a material and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intermediate liquid state. Because the material remains frozen during primary drying, the structure often stays porous. This porous matrix can rehydrate quickly when water is added back. The low pressure also allows vapor to leave the solid matrix without boiling.
A typical cycle begins with freezing, which fixes the material into a solid and determines ice crystal size. Primary drying then raises heat under vacuum so ice sublimes, often near or below the collapse temperature of the formulation. Secondary drying removes bound water that remains after ice is gone, usually by gently warming the product. Each stage balances heat input against pressure to avoid melting or structural damage. Temperature probes and pressure sensors guide the transition between stages.
After primary drying, secondary drying removes water that remains bound to the material. This stage raises the shelf temperature while maintaining low pressure, which encourages desorption of unfrozen water. Residual moisture can be reduced to a low percentage, improving stability for many products. The process parameters, including freezing rate, shelf temperature, and chamber pressure, influence the final pore structure and reconstitution behavior. Control of these variables helps prevent collapse or meltback during drying.
A formulation often contains excipients that protect the active ingredient during freezing and drying. Bulking agents provide structure, while lyoprotectants stabilize sensitive molecules. The freezing step can produce ice crystals whose size and distribution affect the drying rate, and cycle design includes freezing, annealing, and drying phases. If the product temperature rises above a critical value, the cake may collapse or lose its porous structure. Successful lyophilization therefore depends on the interaction between formulation, equipment, and cycle design.
In a retail market that is decriminalized such as in The Netherlands, where wholesale production is illegal but prosecutions are not always enforced because of the contradiction of the law that is recognised by the courts, competition puts pressure on breeders to create increasingly attractive varieties to maintain market share. Breeders give their strains distinct and memorable names in order to help differentiate them from their competitors' strains, although they may in fact be very similar.
== Epidemiology == Duchenne muscular dystrophy is the most common type of muscular dystrophy; it affects about one in 5,000 males at birth. Duchenne muscular dystrophy has an incidence of one in 3,600 male infants. In the US, a 2010 study showed a higher amount of those with Duchenne muscular dystrophy age ranging from 5 to 54 who are Hispanic compared to non-Hispanic Whites, and non-Hispanic Blacks.
1993/549) Removal, Storage and Disposal of Vehicles (Prescribed Sums and Charges etc.) (Amendment) Regulations 1993 (S.I. 1993/550) Housing Renovation etc. Grants (Reduction of Grant) (Amendment) Regulations 1993 (S.I. 1993/551) Housing Renovation etc. Grants (Prescribed Forms and Particulars) (Amendment) Regulations 1993 (S.I. 1993/552) Housing Renovation etc. Grants (Grant Limit) Order 1993 (S.I. 1993/553) Assistance for Minor Works to Dwellings (Amendment) Regulations 1993 (S.I. 1993/554) Academic Awards and Distinctions (Glasgow Caledonian University) (Scotland) Order of Council 1993 (S.I. 1993/555) Glasgow Caledonian University (Scotland) Order of Council 1993 (S.I. 1993/556) Napier University (Scotland) Order of Council 1993 (S.I. 1993/557) University of Paisley (Scotland) Order of Council 1993 (S.I. 1993/558) Further and Higher Education Act 1992 (Consequential Amendments) Regulations 1993 (S.I. 1993/559) Further and Higher Education Act 1992 (Consequential Amendments) Order 1993 (S.I. 1993/560) Taxes (Relief for Gifts) (Designated Educational Establishments) (Amendment) Regulations 1993 (S.I. 1993/561) Education (Designated Institutions in Further Education) (No. 2) Order 1993 (S.I. 1993/562) Education (Designated Institutions in Further and Higher Education) (Interpretation) Order 1993 (S.I. 1993/563) Judgment Debts (Rate of Interest) Order 1993 (S.I. 1993/564) Civil Legal Aid (General) (Amendment) Regulations 1993 (S.I. 1993/565) Controlled Waste (Amendment) Regulations 1993 (S.I. 1993/566) National Health Service (Fund-holding Practices) Regulations 1993 (S.I.
Sources: en.wikipedia.org
In 1914 T. W. Richards found variations between the atomic weight of lead from different mineral sources, attributable to radiogenic variations in isotopic composition; the natural radioactive series ending with three different isotopes of lead.
== Efficacy and side effects == Just like cocaine, dimethocaine inhibits the uptake of dopamine in the brain by interfering with the dopamine transporters. The potency of these drugs is linked to their affinity for the dopamine transporters, and their potency to inhibit dopamine uptake. In studies with rhesus monkeys the affinity of dimethocaine for dopamine transporters is smaller than that of cocaine, whereas dimethocaine's potency to inhibit dopamine uptake is similar. This means that more of dimethocaine is needed to reach a similar response. The peak effects occurred within 10 to 20 minutes after the injection and decreased to baseline levels within an hour. Dimethocaine is often abused as a legal substitute for cocaine. The drug is administered intravenously or nasally, because ingestion would lead to rapid hydrolyzation. Its positive effects are euphoria, stimulation, increased talkativeness and mood lift. However, because the drug acts similar as cocaine, it has comparable negative side effects. These side effects include: tachycardia, difficulty with breathing, pain on the chest, vasoconstriction, insomnia, paranoia and anxiety. Dimethocaine probably poses larger health issues than cocaine. This is due to the fact that more dimethocaine must be administered to produce the same euphoric feeling, resulting in larger risk for the negative effects.
27 May A new compact CRISPR gene editing tool better suited for therapeutic (temporary) RNA editing than Cas13 is reported, Cas7-11, – of which an early version was used for in vitro editing in 2021. Science and the 2022 Russian invasion of Ukraine:According to a news report academics in Russia are compiling or circulating a list of researchers who have supported Russia's invasion to prevent them from being elected to the Russian Academy of Sciences. An editorial published in a journal notes that remote surgery and types of videoconferencing for sharing expertise (e.g. ad hoc assistance) have been and could be used to support doctors in Ukraine (3 May). A forum contribution analyzes Russian users' reactions to the Bucha massacre on social media – on nationalist Telegram channels (9 May). The FAO estimates that "at least 20 percent of Ukraine's winter crops" "may not be harvested or planted" (13 May). A preprint estimates potential impacts of the EU embargoing fossil fuels from Russia, suggesting implementing such via a partial embargo with tariffs may be beneficial (25 May). 28 May – A new direct air capture system using isophorone diamine is demonstrated, able to remove carbon dioxide with 99% efficiency and more than twice as fast as existing systems. 30 May – Frontier is announced by Oak Ridge National Laboratory as the world's first exascale supercomputer. 31 May – Success of record-long (3 days rather than usually <12 hours) of human transplant organ preservation with machine perfusion of a liver is reported.
Sources: en.wikipedia.org
Freezing only converts liquid to solid. Lyophilization adds vacuum and controlled warming so frozen solvent sublimes, leaving a dry porous solid. The two steps are related but not interchangeable.
Reduced pressure keeps the solvent below its triple point, allowing ice to become vapor without melting. Vacuum also helps remove water vapor from the product chamber. The exact pressure is chosen with the formulation and equipment.
Residual moisture is water that remains in the dried solid after secondary drying. It is often measured by Karl Fischer titration, near-infrared spectroscopy, or thermogravimetry. Acceptable levels depend on the material and its stability profile.
Simple drying usually removes water by evaporation from a liquid or solid, often with heat. Lyophilization first freezes the material and then removes ice by sublimation under vacuum. This avoids prolonged exposure to liquid water and high temperatures.